Stupid question alert ---- So I'm reading the manual for 3.0 and it talks about the installation being just as simple as dragging the WeatherCat icon onto the Application folder icon to install WeatherCat.
"To upgrade to WeatherCat 3 from WeatherCat 1 or 2, first quit your existing WeatherCat then open the WeatherCat 3 disk image you downloaded from our web-site. Drag the WeatherCat application over the Applications folder in the disk image then run the new WeatherCat (which will be found in your Applications folder). Do not run WeatherCat directly off the disk image.
After installing WeatherCat 3 into your Applications folder, you can delete, or zip up and then delete, your old WeatherCat folder - it is no longer used or required."
At this point: If I start the new WeatherCat 3.0, will it read in all of my settings from the previous version of WeatherCat 2/DavisStation setup and then use my weather cat 2 configuration (and data), start uploading my new/current weather data (and or do I need to setup WeatherCat 3.0 by entering all the settings by hand...?
I'm unsure about the upgrade as I read the manual.
Thanks,
nowait