Trixology

WeatherCat => WeatherCat General Discussion => Topic started by: jace on May 28, 2012, 06:09:26 PM

Title: Unwanted rain reading on graph's
Post by: jace on May 28, 2012, 06:09:26 PM

Hi all

I was taking advantage of the dry weather to check the calibration of the rain gauge today. had the console in 'standby' mode, and weather cat disconnected from the console. Cal check was ok, reset the console daily rain readings etc, reconnected Wcat, and lo ! lots of rain data, listed on  [cat]

I've cleared the rain/hr and daily rain using the data editor, but I have massive spikes on my rainfall mm/hr charts, is there any way to correct this ?

Cheers

JC

Title: Re: Unwanted rain reading on graph's
Post by: WCDev on May 28, 2012, 08:10:50 PM

Hi JC,
Try giving WeatherCat a restart - it might be a cache hanging on to the data.

Cheers,
Stu.